Jackson 24 LT, 24LTP 1/2” SOLENOID VALVE & 1/2” NPT VACUUM BREAKER REPAIR PARTS KITS

1/2” SOLENOID VALVE & 1/2” NPT VACUUM BREAKER REPAIR PARTS KITS

Screw

Data Plate

Coil & Housing

Valve Bonnet
	Spring
	4810-200-04-18
	Plunger
	4810-200-04-18
Diaphragm	O-Ring
	4810-200-03-18
Retainer
	Diaphragm
	4810-200-03-18

Screen

Retainer

Mesh Screen

Valve Body

Cap Screw

Data Plate

Cap

Cap Retainer
	O-Ring
	Plunger
Components of Repair Kit
4820-001-60-56	Body

Complete 110 Volt Solenoid Valve Assembly

4810-100-12-18

Coil & Housing only

4810-200-01-18

Possible Problems:

1.Pilot port extension #1 clogged. Clean hole.

2.Hole #2 Clogged. Pass heated straight pin through hole.

Complete Vacuum Breaker Assembly

4820-300-07-00

TO TAKE THE SOLENOID VALVE APART

DISASSEMBLY - These valves may be taken apart by unscrewing the bonnet and the enclosing tube assembly from the valve body assembly. After unscrewing, carefully lift off the bonnet and enclos- ing tube assembly. Don’t drop the plunger. The o-ring seal and diaphragm cartridge can now be lifted out. Be careful not to dam- age the machined faces while the valve is apart.

1

2

TO REASSEMBLE - Place the diaphragm cartridge in the body with the pilot port extension UP. Hold the plunger with the synthetic seat against the pilot port. Make sure the o-ring is in place, then lower the bonnet and enclosing tube assembly over the plunger. Screw the bonnet assembly snugly down on the body assembly.

25