www.jacksonmsc.com
Prying open the coil wire cover
4.When replacing the coil, ensure that when removing the coil wire cover that care is taken not to damage the wires inside. Using the medium flathead screwdriver, gently use it to open the cover enough to where it could be pulled off.
Straightening the wires
5.Once the coil wire cover has been removed and set to the side, take the internal wires and pull them out straight.
Removing the wire nuts
Loosening the conduit nut
7.Using a pair of channel locks, gently loosen the conduit retain- ing ring for the conduit nut. Once it is loosened, use your fingers to unscrew and remove it.
8.Pull the conduit away and discard the bad coil. Take the new coil and attach the conduit, reinstall & tighten the conduit nut, and pullg the wires through so that you will be able to wire the valve back up.
9.Reconnect the wires from the conduit to the wires from the sole- noid as they had been connected previously. Ensure that the wire nuts are on tight.
10.Slide the coil wire cover back on, taking care not to damage the wires.
11.If you are done performing maintenance on the valve, continue on to step 23. Otherwise, please go on to step 12.
Loosening the valve bonnet
6. Remove the wire nuts from the wires and separate them.
12.To remove the valve bonnet, grasp it with the jaws of the pipe wrench and turn to the left. Note: on some models you may have
Parker Style Solenoid Valve Repair Kit Instructions | 3 | |
Revision A (04/15/2005) | ||
|
