M24STD-6 INSTALLATION INSTRUCTIONS
Tools Required:
•Standard Allen wrench set
•Tube of
•Silicon gun
•Rag
Time Requirements:
It is expected that it will take 30 minutes to install the
Notes:
•Ensure that the dishmachine stand is level prior to placing the dishmachine on the stand.
•Never attempt to lift a dishwasher on your own. Always use other personnel to help or the appropriate lifting devices to prevent accident and injury.
Steps:
•Inspect the assembly to ensure that there has been no freight damage. If there is any damage, contact the freight carrier immediately.
•Your package should contain the fol- lowing:
•Stand platform weldment
•(4) legs
•Instructions
•If any of these items are missing, im- mediately contact Jackson Technical Service at
•Remove the items from the box.
•Ensure that the set screws are located within the leg sockets. If they are miss- ing, immediately contact Jackson Technical Service (See Figure 1).
•Verify that the foot of each leg can be turned; this is how the stand will be ad- justed in order to level it. Please note that when assembled, there should be a minimum of 6” (152.4mm) of space between the bottom of the stand and the finished floor.
Figure
•Place the legs fully into the leg sockets of the platform and tighten down the set screws to secure them in place. (See Figure 2).
•Once all of the legs are tightly in place,
Figure
flip the dishmachine stand over and set it down on all four legs. Ensure that the legs are stable.
•If stable, take a small amount of silicon and apply it to the set screw to cover any exposed threads and to fill in the hole for the Allen wrench. (See Figure 3). Note: do not use excessive amounts of silicon; only enough to complete the task.
Installation Instructions
2