MAINTENANCE INSTRUCTIONS
REPLACING CONVEYOR MOTOR
The instructions provided here are for maintenance per- sonnel only. Unauthorized persons should not attempt any of the steps contained in these instructions.
Warning: many of the instructions and steps within this document require the use of tools. Only authorized per- sonnel should ever perform any maintenance procedure on the dishmachine!
PREPARATION
1.Power must be secured to the unit at the service break- er. Tag or lock out the service breaker to prevent accidental or unauthorized energizing of the machine.
2.Ensure that incoming water to the machine is secured either by use of a
3.Ensure that the dishmachine has been completely drained of water and has been allowed to cool down prior to begin- ning this maintenance procedure.
STEPS
1. Remove the (4) nuts holding the mounting plate in position.
Removing the mounting plate nuts with the 9/16” socket
TOOLS REQUIRED
The following tools will be needed to perform this mainte- nance evolution:
1.7/16” socket and ratchet with extension
2.9/16” socket and ratchet with extension
3.5/16” Allen wrench
4.5/16” nutdriver
5.Large flathead screwdriver
6.Small flathead screwdriver
TIME REQUIRED
It is estimated that it will take (1) person one and a half hours to perform this task, not including all of the items indicated in the section entitled “PREPARATION”.
IMPORTANT NOTES
1.Read these instructions thoroughly before attempting this maintenance procedure. Become familiar with the parts and what actions need to be taken. This will save time in the long run!
2.The procedures demonstrated in this manual are shown being performed on an
3.These basic instructions will apply to all prewash, wash and power rinse motors found on AJ, TS and TSC series machines.
2.Loosen the band clamp on the back end of the motor.
3.With the band clamp loosened, carefully remove it from the back end of the motor. Once the clamp is removed, examine it to deter- mine if it needs to be replaced as well. If it is broken in any spots or shows signs of metal fatigue, it is best to order a new one. The purpose of the clamp and the attached support bracket is to keep the weight of the motor from pulling on the tub, damaging it. It is absolutely necessary that this component be replaced once the maintenance procedure is completed.
Loosening the band clamp on the back end of the motor.
Conveyor Motor Replacement Instructions
Issued:
2
