MAINTENANCE INSTRUCTIONS
REPLACING CONVEYOR MOTOR
Removing the rear clamp
4. Remove the motor support bracket.
Removing the pump gasket
10.Remove the wiring cover on the new motor assembly and pull the wires free. Install the conduit fitting.
11.Run the conduit to the motor, pulling the machine wires through and into the motor wiring box.
12.Rewire the motor exactly the same way the old one was wired and/or refer to the motor schematic to determine how the motor should be wired for the incoming power. If you require help on this, do not hesitate to contact Jackson Technical Service. Ensure that all wiring is done in accordance with national, state and local codes as applicable.
Removing the motor support bracket
5.With the motor support bracket removed, gently pull back on the motor. You may have to move it from side to side, but it should start to move back. Pull it completely away from the mounting studs on the tub and set down gently to work on it.
6.Remove the gasket from the tub.
7.Use a screwdriver to remove the wiring cover from the motor wiring box. Take note of how the motor is wired up because you will have to wire it up the exact same way when you install the new motor.
8.Remove the conduit fitting from the motor wiring box.
9.Pull the conduit away from the motor and set old motor to the side. Dispose of the old motor in accordance with warranty or national/state/local guidelines, whichever may apply.
Remounting the wash motor assembly
13.Place the new motor gasket on the tub over the mounting studs.
14.Carefully lift the motor assembly and slide it onto the mounting studs.
15.
Conveyor Motor Replacement Instructions
Issued:
3
