Jacuzzi Neo Angle Shower System installation instructions Step, ROUGH-IN Plumbing Details

STEP 2. ROUGH-IN PLUMBING

A.Install water lines and rough plumbing. Valve should be located between 36" and 48" from the floor. Use blocking and secure with pipe straps.

B.If stationary shower is used, install shower riser. Suggested shower head location is 78" from the floor (above the endwall).

C.The locations of the valves, mixers, and shower head should be determined before the walls are placed in position. Where access to connections is limited, allow enough flexibility in the supply lines for easier position- ing of the valves after the unit is in place.

From stable reference points such as subfloor and front of the double studs, measure and note the locations of the valves, shower head arm and connec- tion for body spray jets.

STEP 3

Install Shower Base per Shower Base Instructions.

A.For proper fit and installation of the custom shower system it is imperative that the shower base is level on all sides and the wall structure is plumb.

NOTE: Watertight installation of the drain is the installer’s responsibility. Drain leakage is excluded from the Jacuzzi Whirlpool Bath warranty of this product. (See “Drain Installation Instructions” provided with drain.)

ROUGH-IN PLUMBING DETAILS

BLOCKING

TO SHOWER HEAD

TO BODY SPRAY JETS WALL

(IF NEO WALL IS EQUIPPED WITH JETS)

OPTICA 300
MIXER AND		78"
TRANSFER
VALVE		(FOR FIXED
		SHOWER
		HEAD)
12" CLEARANCE		36" MIN.
FOR PLUMBING
		48" MAX.
AT SEATWALL
		24"
CENTERLINE	SUPPLY LINES

SUGGESTED PLUMBING LAYOUT	OPTICA 300 CONNECTIONS
(REVERSE FOR LEFT HAND SEAT WALL VERSION)	TO SHOWER HEAD OR HAND HELD SHOWER

TO BODY SPRAY WALL

MxF ADAPTER (3)

LINE TO WALL		COPPER GASKET (4)
BAR SHOWER
HEAD OR	TRANSFER
SHOWER
	VALVE
HEAD
LINE TO BODY
SPRAY JETS
WALL (IF BACK
WALL IS		LEFT-HAND
EQUIPPED
WITH JETS)		THREAD TO
		SWEAT ADAPTER
OPTICA 300		COPPER PIPE
MIXER/	HOT IN
TRANSFER
VALVE		COLD IN
HOT
WATER
SUPPLY		MIXER VALVE
COLD
WATER
SUPPLY