Contents
Main
Page
Product Information
Contents
READ AND FOLLOW ALL
INSTRUCTIONS. SAVE THESE INSTRUCTIONS
always be followed, including the following:
Page
Introduction
Typical flange mounting Detail
Undermount Installation Options
Page
framing and Support
Suboor
Electrical Connections
XXFor the pump/motor, install a 120 VAC, 15AMP,
Pump/motor
XYUsing a #8 solid copper wire, ground the pump
X[At initial start-up, and before each use thereafter
XXWith a #8 solid copper wire, bond the heater to the
XXPush the GFCI test button. The reset button should
XYPush this button in to reset. If the interrupter fails
XZTurn off power and do not use the bath until the
Drop-in Installation
XXInstall drain/overow according to the
XYInstall the faucet at this time. It is recommended
XZPrepare the cut-out hole for the bathtub using the
X[Complete all deck nish work and cover to protect
X^Install the unit, inserting the motor/pump end rst,
Drop-in Installation (cont)
X_Connect ex water supply lines to faucet and plug
X`Remove scrap lumber and lower the bathtub
XaTurn on the power supply to the dedicated GFCI
XXInstall the drain/overow according to the
XYInstall the faucet at this time. It is recommended that
XZInstall the ange (purchased separately) according
X[Place the bathtub into the niche. Screw the ange to
X^Align the bathtub and connect the drain. X_Connect ex water supply lines to faucet and plug
ON/Off Button
Operation
Rapdheat Operation
Whirlpool Control
Bathtub Additives
Purging the Whirlpool System
Surface Repair
maintenance
Suction Cover/Strainer maintenance
Troubleshooting Procedures
before work is started. The serial number is located on the Specication/Serial Number Plate.
PROBLEM PROBABLE CAUSES REMEDY
Installation and Operation www.jacuzzi.com Page 21
Technical Specications
BATHS WITH INTEGRAL SkIRT
1"
*Add " (6 mm) to this dimension when roughing-in for 3-wall niche.
BATHS WITHOUT INTEGRAL SKIRT, 542BM & 6032
Specications - Corner (Right Hand and Left Hand)
DRAIN/OVERFLOW
ESPREE 6060 WITH SKIRT
SPECIFICATIONS
*Add " (6 mm) to this dimension when roughing-in for 3-wall niche.
Page
Roughing-In Reference
60" 60" 14" x 4" 8- " 3"
Cut Outs
Authorized Service
Warranty
Jacuzzi Luxury Bath
14525 Monte Vista Avenue Chino, California 91710
EnglishEspaol
WARRANTy
JACUZZI LUXURy BATH
REGISTRATION CARD
Ninety-Day Parts Only
