Jasco 19200 installation instructions Chime Tune Setting

Battery Release Tab

2.Install 4 C-cell batteries (we recommend Alkaline Batteries)

3.Remove back of wireless push button and install the 12-volt battery (included) as shown below.

Chime Tune Setting

All wireless chimes may have more than one push button. The chime tune for each push button is set with jumpers 7-9.

Single Push Button Kit: If you purchased a kit with a single push button, the chime tune will be set to Ding Dong from the factory.

Dual Push Button Kit: If you purchased a kit with two push buttons, one push button will be set to Ding Dong and the other push button will be set to Westminster from the factory.

The following instructions explain how to change the tune on any wireless push button.

1.Remove the battery from the push button transmitter.

2.Locate the 9 position jumper shown below.

9 position jumper (This pushbutton is set for Ding Dong Chime since 7=off, 8=on,