Jasco RM25001 instruction manual Sleep Timer, Setting ALLVolume/Mute Control to any one Mode

Setup, cont.

Any Mode chosen forVolume/Mute control MUST have its own Volume/Mute function or the Volume/Mute buttons will do nothing.

Setting ALLVolume/Mute Control to any one Mode

This routine can set all Modes to “punch-through” to any one chosen Mode for Volume/Mute button control without the needing to change to that Mode.

1.Press and hold the SETUP button until the green indicator turns on, then release the button.

2.Press and hold the MUTE button until the green indicator blinks off, then release the button.

3.Press and release the desired Mode button (TV, VCR, etc.) for Volume/Mute control, the green indicator blinks then stays on.

4.Press and release the MUTE button and the green indicator turns off. The green indicator will blink rapidly for three seconds if the Mode you have selected has no Volume/Mute control.

5.All other Modes will now punch-through to your chosen Mode for Volume/Mute control.

6.All “Visual” and “Audio” programmed Modes will now punch-through to the respective Modes you have chosen for Volume/Mute control.

Setting any Mode to use its own Volume/Mute Control

This routine can set any Mode to use only its own Volume/Mute control. Note - If your chosen Mode has no Volume/Mute functions of its own then the Volume/ Mute buttons will do nothing.

1.Press and hold the SETUP button until the green indicator turns on, then release the button.

2.Press and hold the MUTE button until the green indicator blinks off, then release the button.

3.Press and release the desired Mode button (TV, VCR, etc.), the green indicator blinks then stays on.

4.Press and release the VOLUME- (Down) button, the green indicator blinks then stays on.

5.Press and release the MUTE button and the green indicator turns off.

6.All “Visual” and “Audio” programmed Modes will now punch-through to the respective Modes you have chosen for Volume/Mute control.

Sleep Timer

The SLEEP button enables the remote to turn off your TV after a period of 1 to 99 minutes as shown below. The remote must be in TV mode to set a Sleep Timer. This feature works even if your TV does not have a sleep feature.

1.Press and release the TV device button.

2.Press and hold the SLEEP button until the green indicator remains lit (about 2-3 seconds).

3.Release the SLEEP button.

4.Press and release the numeric buttons (01-99) for the time required. The green indicator will blink off to indicate button press acceptance.

5.TV Sleep Timer is set.

6.Leave the Remote pointing towards the TV with an unobstructed path.

To cancel the Sleep Timer, press and hold the SLEEP button until the green indicator blinks, or press and release the ON-OFFbutton in TV mode.

12 13