JBL CS600SAT WALL-MOUNTING the Satellites, Fixed-Mount Wall Bracket, Adjustable Wall Bracket

WALL-MOUNTING THE SATELLITES

The CS600SAT is designed to be mounted on the wall. There is a

Step 4. Unscrew round collar (C) from bracket (A).

fixed-mount wall bracket and an adjustable wall bracket provided for each satellite. Each speaker bracket will require up to four

1-1/2"#10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2"#10 screw.

NOTE: The customer is responsible for the correct selection

A

B

C

and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.

Fixed-Mount Wall Bracket

Step 1. Mark the positions on the wall where you would like to place the mounting screws.

Step 2. Attach the bracket to the wall using two screws (not included).

Step 3. Remove the rubber ring on the bottom of the satellite, and seat the satellite speaker onto the back bracket.

Step 4. Attach 1/4" -20 screw into insert on bottom of speaker and tighten.

Step 5. Screw the ball and shaft assembly (B) to the 1/4"-20 insert on the back of the satellite (do not use the bottom insert on the speaker). Back out 1/2 of a turn and tighten the nut against the speaker. If the ball and shaft assembly is not backed out before tightening the nut, performing Step 8 below may dislodge the threaded insert in the speaker housing and permanently damage the speaker.

Step 6. Attach speaker wire as shown on page 5.

Step 7. Drop round collar (C) over ball and shaft assembly (B) that is mounted to the speaker with the finished side of the collar facing the rear of the speaker.

Step 8. Carefully push the ball straight into the socket mounted on the wall, angle the speaker as desired and tighten the collar using the enclosed metal bar.

Adjustable Wall Bracket

Step 1. Remove cap over threaded insert on rear of speaker.

Step 2. Mark the positions on the wall where you would like to place the mounting screws.

Step 3. Place bracket against the wall and fasten four 1-1/2" #10 wood screws through the bracket’s screw holes into the wall. If a wall stud is not available, use an appropriate anchor.

Metal bar

Figure 3. Bracket on wall.

4