![](/images/new-backgrounds/1001238/123823x1.webp)
Voltage Selection And Fuses
Changing Voltage
Your EON Sub G2 will typically be set at the factory to accommodate the power mains voltage in your area. Before you set up your EON Sub G2 for the first time it is a good idea to verify that the setting of the selector is appropriate for the power in your area. Directly below the IEC power con- nector you will see a seal that indicates the factory setting for the voltage. If the voltage indicated is correct for your area, go ahead and power up your EON Sub G2.
In the event that you do need to change the voltage:
•Make sure that the AC is disconnected from the speaker.
•Directly below the male IEC connector on the speaker is a voltage selector. Break the factory- applied seal.
•Set the voltage selector switch to the 115V or 230V setting as required for your area.
•After having reconfirmed that the correct voltage is selected, connect the AC (IEC connector) and power the unit up.
DO NOT UNDER ANY CIRCUMSTANCES OPERATE THE UNIT WITH THE WRONG VOLTAGE SELECTED. DOING SO MAY RESULT IN SERIOUS DAMAGE TO YOUR SPEAKER SYSTEM WHICH WILL NOT BE COVERED BY WARRANTY.
Fuse Replacement
The EON Sub G2 has no
| Troubleshooting |
|
|
|
|
|
|
| Symptom | Likely Cause | What to do |
| No sound | Speaker not connected to | Verify that speaker is connected |
|
| active AC power. | and that the circuit is on. |
|
| Power not switched on. | Switch on power and verify that |
|
|
| power LED is on. |
| No sound, speaker is | Speaker power cable is faulty | • |
| connected to working AC | or improperly connected. | ends. |
| power but won’t come on. |
| • Substitute a |
|
|
| cable. |
|
| Blown fuse. | • There are no |
|
|
| fuses in the EON SUB G2. Take |
|
|
| your speaker to a competent |
|
|
| servicer. |
| No sound. Speaker comes | Signal source (mixer, | • Check VU meters on the source |
| on. SIGNAL LED does not | instrument, etc.) is not | mixer. |
| illuminate. | sending. | • Verify that the tape or CD is |
|
|
| playing. |
|
|
| • Use headphones to verify that |
|
|
| the instrument is actually sending |
|
|
| an audio signal. |
|
| Faulty cables and | • Disconnect and |
|
| connections. | cables. |
|
|
| • Replace suspected cable with a |
|
|
| |
| Signal sounds distorted and | Excessive input signal, trying | • Reduce the output level of the |
| very loud, PEAK light is lit | to exceed the capabilities | source. |
| most of the time. | of the speakers. | • Turn down the LEVEL controls on |
12 |
|
| the speaker. |
|
| • Use additional EON speakers. | |
|
|
| |
|
|
|
|