![](/images/new-backgrounds/1001238/12389x1.webp)
•Keep the exterior of the speaker enclosure clean. Use a damp rag with a
•EON speakers are not intended for fixed installation in outdoor environments. Moisture can damage the speaker cone and surround, cause corrosion of electrical contacts, and create an electrical shock hazard. Protect your speakers from moisture. Avoid exposing the speakers to direct moisture. Any electrically powered device can produce dangerous shock hazards when wet or exposed to moisture. Keep speakers out of extended or intense direct sunlight. The driver suspension will prematurely dry out and finished surfaces will be degraded by
•The EON Sub G2 contains no user serviceable parts. Refer servicing to an authorized JBL service agency.
Stand Mounting and Precautions
Your EON speakers include a 35mm receptacle cup to facilitate mounting on tripod stands. When using stands, be sure to observe the following precautions:
•EON speakers include a
•Check the stand specification to be certain it is designed to support the weight of the speaker (see specifications). Observe all safety precautions specified by the stand manufacturer.
•Always verify that the stand is placed on a flat, level, and stable surface.
•Route cables so that performers, production crew, and audience will not trip over them and pull the speaker over.
•Be sure to fully extend the legs of tripod type stands.
•Position the stand so that the legs do not present a trip hazard.
•Do not attempt to place more than one speaker on a stand designed for a single speaker.
•Always be cautious in windy, outdoor conditions. It may be necessary to place additional weight (i.e. sandbags) on the base of the stand to improve stability.
The EON Sub G2 generates considerable energy. When placed on a slippery surface such as polished wood or linoleum, the EON Sub G2 may move due to its acoustical energy output. Precautions should be taken to assure that the speaker does not fall off a stage or table on which it is placed. One solution is to place the speaker on a rubber mat.
Electrical Safety
All EON powered series speakers are fitted with a detachable power cord (supplied) which connects to the AC mains on the back panel of the loudspeaker. The power cord has an IEC female connector on one end and a male mains connector on the other end. This cord is supplied to accommodate the different worldwide safety and electrical code requirements. If the power cord supplied with your EON product has a
5