INSTALLATION
INTERMOUNT III*
MOUNTING RINGS
The GTO607C is packaged with two different speaker adapters. The adapters will allow the speakers to be installed into various factory 6,"
Figure 3. Mounting the GTO607C using the supplied metal adapter. Mounting with the plastic adapter is similar.
FLUSH-MOUNT
Figure 5A. Mounting the tweeter using the I-Mount flush-mounting kit.
3
1 
2 
SURFACE-MOUNT
Figure 5B. Mounting the tweeter using the I-Mount surface-mounting cup.
TWEETER ANGLE
Figure 6. Aim the tweeter at the listening position by sliding the screw in the groove on the back of the tweeter cup and lock the tweeter in place using the small retaining screw. Rotate the entire assembly in the mounting surface and tighten the large hand nut.
3
ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.
1
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
2 
Figure 7A. Surface-mounted behind grille panel.
Figure 7B. Flush-mounted to surface behind grille panel.
FOAM GASKET
MOUNTING RING
Figure 4. Mounting the GTO607C woofer without the metal adapter.
FOAM GASKET
1
ATTACH BASE
WITH SCREWS, THEN:
2 
3
BLACK 
RED (+)
TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.
4
SECURELY TIGHTEN
THE LARGE HAND NUT.
Figures 7A through 7D. The Starfish™ tweeter mount is intended to be used when the tweeter will be installed behind a factory grille (e.g., replacing the factory tweeter behind a door panel). The Starfish will allow you to mount the component tweeter directly to the panel itself or to the area behind the panel. The six mounting tabs can be removed easily to create a number of custom configurations.
Note: Check screw clearance before installing. Use glue if clearance is an issue.
Note: Not all possible mounting configurations are shown.
Figure 7C. Mounted to grille panel.
Figure 7D. In-dash location (may require gluing).
* patent no. 6,505,705 | 3 |
