EXISTING CONSTRUCTION

HTI6, HTI8, HTI55

Level

Template

1/2"

1/2"

1/2"

English

Remove the grille from the speaker frame by pulling on the paper tab. If the tab is missing, to avoid scratching the grille or baffle you may unfold a paper clip, insert the straight end through one of the holes in the grille, and gently pull up.

Cut the drywall.

Screw down each of the four (six for HTI55) Phillips head screws. The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.

Determine the correct speaker location.

Note: Remove the inner tem- plate, which is the paint shield, at the perforation. Use the outer template when cutting the drywall. Although the HTI55 may be oriented either horizon- tally or vertically, the installa- tion procedure is the same.

Connect the speaker wires to the speaker.

The HTI speakers feature unique swivel mounts for the tweeters that enable you to aim the very directional high fre- quencies toward the listening position, at ear-level height. Before installing the speaker grille, gently press on the outer edge of the tweeter mount to adjust the position of the tweeter. The tweeter will not swivel more than 15 degrees in any direction; do not attempt to force it to move fur- ther. You may also rotate the tweeter to orient the JBL logo as desired.

Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.

Place the frame assembly in the wall.

Replace the metal grille. For the HTI55 only, attach the JBL logo to the grille to correspond to vertical or horizontal installa- tion.

5

Page 5
Image 5
JBL HT18, HT16C, HT155 manual Existing Construction, HTI6, HTI8, HTI55, Cut the drywall