JBL IS8C, IS5 Existing Construction, Determine the correct speaker location, Cut the drywall

EXISTING CONSTRUCTION

IS5, IS6, IS8

Remove the grille from the speaker frame by pulling on the paper tab. If the tab is missing, to avoid scratching the grille or baffle you may unfold a paper clip, insert the straight end through one of the holes in the grille, and gently pull up.

Determine the correct speaker location.

Note: Remove the inner template, which is the paint shield, at the perforation. Use the outer tem- plate when cutting the drywall.

	≥1/2"
≥1/2"	≥1/2"

Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.

Cut the drywall.

Screw down each of the four Phillips-head screws. The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.

Connect the speaker wires to the speaker.

JBL Performance Integrator speakers feature unique swivel mounts for the tweet- ers that enable you to aim the very directional high frequen- cies toward the listening posi- tion, at ear-level height. Before installing the speaker grille, gently press on the outer edge of the tweeter mount to adjust the position of the tweeter. The tweeter will not swivel more than 15 degrees in any direction; do not attempt to force it to move further. You may also rotate the tweeter to orient the JBL logo as desired.

Place the frame assembly in the wall.

Replace the metal grille.

5