CAUTION
Installers must adhere to local building codes to ensure proper installation. JBL is not responsible for any possible damage caused by improper installation.
4.Feed the power amplifier wires from the wall cavity down through the cable clamp located on top of the enclosure. Pull approximately two feet of wire through the clamp to create a generous service loop inside the enclosure for ease of hookup, as shown in Figure 6.
CableBackClampBox
8.Cut a small hole in the center of the template area to make sure the template is in the right location.
9.After confirming the correct loca- tion, cut the template hole opening, as shown in Figure 7. Use a carpen- ter’s level to ensure the opening is level.
Figure 7: Cut Opening in Drywall
10.Fasten the drywall to the wall studs using drywall screws.
11.Install the speaker mounting frame into the wall opening. Refer to the JBL P81/P941
12.Route wires to the top of the speaker frame to prepare for hookup.
WallIn- Sp | eaker Frame |
–+
Power Amplifier
Figure 6: Amplifier Connections
5.Tighten the clamp screws, cinching the wires in place.
CAUTION
Be sure to comply with local wiring codes. JBL is not responsible for any damage or injuries that may result from faulty wiring.
6.Place the section of drywall over the back box. With tape measure and pencil, carefully measure and mark where to position the wall template (included with the loud- speaker) by using the measure- ments recorded in Step 1.
7.Use the wall template to trace where to cut the drywall.
outeR Wi | res to the Top |
of the Speaker System | |
voidA Cont | act Between |
the Wires and Speaker Cone
Figure 8: Route Wires to Top of the Loudspeaker
6
