JBL S120PII specifications BassQ Jacks, Your system’s bass response

Dolby Digital or DTS (or Other Digital Surround Mode) Connection

Use this installation method for Dolby Digital, DTS or other digital surround processors:

IMPORTANT: Make sure that the LFE toggle switch ™ on the subwoofer is in the “LFE” position. Use the Line Level input jacks ¶ for the Low- Frequency Effects channel. Connect these jacks to the LFE output or subwoofer output on your receiver or amplifier.

Note: If your receiver or amplifier has only one subwoofer output jack, then you may connect the subwoofer output on your receiver/preamplifier to either the left or right Line Level input ¶ on the subwoofer. It makes no difference which jack you choose.

Connect each speaker to the corresponding speaker terminals on your receiver or amplifier.

¡ ™ £

Make sure that you have configured your surround sound processor for “Subwoofer On” or “LFE On.” The front left, front right, center and rear speakers should be set to “Small” or “Large” depending on their size and frequency response. Consult your receiver’s or processor’s owner’s manual.

180°	LFE	ON
PHASE		AUTO
0°	NORMAL	OFF
80Hz

RECEIVER/PREAMPLIFIER	CROSSOVER				LEVEL
	FREQUENCY
Subwoofer		50Hz 150Hz	MIN	MAX
Output/LFE
	BASSQ				LINE
					LEVEL IN
	(See owner’s				(For LFE
	manual	IN	OUT	R	use R or L)
	before use)				L
				L
					HIGH
					LEVEL
					IN
				R

¢

∞

§

¶

•

BassQ™ Jacks

The jacks marked “BassQ” § are for use with the JBL BassQ bass equalization module that will be released in the near future. The BassQ will enable you to optimize

+–

L

HIGH	ª
LEVEL

OUT

R

your system’s bass response	device. Do not use the BassQ
by equalizing the output of	jacks § without having first
multiple subwoofers to	read the BassQ owner’s
best match your listening	manual.
environment. DO NOT con-	5
nect these jacks to any other