adaptor onto the back of the speaker in two places, as shown.
The floor stand adaptor screws may be found in Hardware Bag B. Use the larger screw in the upper screw hole, and the smaller screw in the lower screw hole.
WALL-MOUNTING
Screw the floor stand adaptor into the floor stand’s threaded insert until the speaker is firmly attached to the stand. Back off slightly from the fully tightened position until the speaker is oriented as desired, then rotate the thumbwheel at the bottom of the floor stand adaptor to
secure the speaker to the stand.
4
32
1
8
5
7
6
1 2
3 4
5
8
Important Safety Note: The customer is solely responsi- ble for proper selection of mounting hardware not included with the speakers, and for proper assembly and installation of the wall- brackets, including but not limited to the selection of appropriate
Step 1: Unscrew and remove the large Molded Nut ™. If necessary, use the supplied
Metal Bar ∞ as a lever by inserting it into one of the holes in the outer edge of the Molded Nut ™.
Step 2: Firmly grasp the Ball and Shaft £ and pull it straight out of the Attach- ment Plate ¢. Avoid leaning it to the side for leverage, as this may break off a tab. Step 3: Slide the Molded Nut
™onto the Ball and Shaft £ with the threaded open- ing facing the ball. Thread the Metal Nut ¡ all the way onto the Ball and Shaft £, with the star washer side away from the ball. Refer to the exploded drawing for the proper orientation of parts.
Step 4: Screw the Ball and Shaft £ into the Threaded Insert § on the back of the Satellite Speaker ¶ until it is fully seated in the Threaded Insert §, but do not tighten, as you might dislodge the Threaded Insert
§. Such damage would not be covered under the warranty.
Step 5: Tighten the Metal Nut
¡with the star washer side between the Metal Nut ¡ and the back of the Satellite Speaker ¶, using large
6
