JBL SMS1 owner manual Wire Management Clips

Step 5: Remove the logo badge from the SMS1-SAT, insert the INCLUDED 3mm hex key, loosen the InvisiBall clamp by turning the hex key counter-clockwise and place the InvisiBall Receptacle over the Ball.

Step 6: Turn the hex key CLOCKWISE until the mechanism begins to clamp down on the InvisiBall.

Step 7: Before the mechanism is fully tightened, aim the SMS1-SAT on the ball. Then tighten the mechanism until it holds the speaker in place.

Step 8: Replace the Logo Badge on the front of the Satellite.

Step 9: Connect the speaker wires to the speaker observing correct polarity. The Red terminal is the Positive.

Step 10: Wire management clips are included. Insert the speaker wire into the clip and fasten the clip onto the Invisiball Shaft.

Figure 12 – Wire Management Clips

NOTE: The same InvisiBall arms can be used for ceiling mounting the SMS1-SAT.

15