JBL SSLCR manual SS6C, SS6DT, SS8C

EXISTING CONSTRUCTION

SS6C, SS6DT, SS8C

Remove the grille from the speaker frame by pulling on the paper tab. If the tab is missing, to avoid scratching the grille or baffle you may unfold a paper clip, insert the straight end through one of the holes in the grille, and gently pull up.

1/2"

1/2"

1/2"

Determine the correct speaker location. Note: Remove the inner template, which is the paint shield, at the perforation. Use the outer template when cutting the drywall.

Cut the drywall. Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.

Connect the speaker wires to the speaker.

The SS6C and SS8C speakers feature unique swivel mounts for the tweeters that enable you to aim the very directional high frequencies toward the listening position, at ear-level height. Before installing the speaker grille, gently press on the outer edge of the tweeter mount to adjust the position of the tweeter. The tweeter will not swivel more than 15 degrees in any direction; do not attempt to force it to move further. You may also rotate the tweeter to correctly orient the JBL logo as desired.

Place the frame assembly in the wall.

Replace the metal grille.

Screw down each of the three Phillips-head screws. The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.

6