JBL service manual Venue SUB12, System Connections

Venue SUB12

SYSTEM CONNECTIONS

If you have a Dolby® Digital or DTS® receiver/processor with a low-frequency-effects (LFE) or subwoofer output:

	SUBWOOFER OR
	LFE OUTPUT
	LEVEL
	Green: On	Max
	Red: Standby Min
	LFE	NORMAL
	PHASE 0º	180º
	80Hz
	CROSSOVER
	FREQUENCY
	50Hz	150Hz
Set LFE/Normal switch to “LFE.”	L	R
	LINE LEVEL IN
	For LFE use L or R

If your receiver/processor does not contain a Dolby Digital or DTS processor, but has subwoofer outputs:

If your receiver/processor does not have subwoofer outputs for the left and right channels or an LFE output, connect speaker wire from your receiver/amplifier to your speakers and subwoofer using two sets of speaker wire:

LEVEL

Green: On
Red: Standby	Min	Max

LFE NORMAL

PHASE 0º 180º

RECEIVER/AMPLIFIER		80Hz
Front Speaker Output	CROSSOVER
	FREQUENCY
	50Hz	150Hz
	L	R
	LINE LEVEL IN
	For LFE use L or R
		L
		HIGH
		LEVEL
		IN
		R

RECEIVER/PROCESSOR

L R

LEVEL

Green: On	Min	Max
Red: Standby

LFE NORMAL

PHASE 0º 180º

80Hz

CROSSOVER

FREQUENCY

50Hz150Hz

L R

LINE LEVEL IN For LFE use L or R

L

This figure shows how to connect bare wires to the terminals.

Set line-level/LFE switch to “Normal.”

HIGH

LEVEL

IN

R

+ –

NOTE: If your receiver/processor has only one sub out, you may use either the L or R input.

6