days of purchase. Not only will your amplifier be registered, but you will, in the future, be informed of new products and services.
We strongly suggest that you save all packing materials
The amp can be lifted out of its crate while still wrapped in the plastic bag and surrounded by the protective foam.
Installation
Locate the amplifier as close as possible to its final installation point. Allow access to the back panel for making connections. All Jeff Rowland Design Group products are convection cooled, eliminating the need for a fan. When operating, the amp should have at least 2 inches of space on all sides. It is acceptable to stack the amplifiers only if fresh air is allowed to circulate around them.
When the amp is in position, the power cord should be inserted first at the inlet on the amplifier back panel, then connected to an appropriate power source. The amplifier is equipped with a
Pressing the dimly lit push button will switch the amplifier on for normal operation. Note that the lamp intensity will increase and a faint "click" will be heard. All subsequent on- off cycles should be initiated by the front panel switch.
If the front panel switch does not light, the amplifier does not power up or a fuse blows, disconnect AC power, refer to the troubleshooting section of this manual or contact your dealer.
Input Impedance Selection
Your amplifier is provided with