1.Cut hole in cabinet to mount oven. Cutout in cabinet should be level and straight,
Note: There are no provisions to level the unit after it is installed. An oven that is not level could cause poor baking results,
2. Install plywood floor as shown above.
3. Attach unit to the cabinet with four No. 8xl/2" screws
supplied with unit inside of envelope containing these instructions.
screws using 1/8" drill. Oven mounting holes are
provided in side trim.
4.See instructionsbelow for electrical
5=.e User'sManual for operating instructions.
Installing Bottom Trim Piece
ElectricalConnections
Unit to be properlycircuit protected and wired according to local electrical code and National Electrical Code.
It is advisable that the electrical wiring and hookuF C."'_ accomplished by a competent electrician.
120/240 VAC or 120/208 VAC 60 Hz. See serial plate on front of unit for power requirements.
The neutral of this unit is grounded to the frame through the green or solid grounding wire. (The green and the white wires are twisted together at the termination of the conduit.) If local conditions do not permit grounding of the neutral, untwistthe greenwire and connectthe green wireto ground
in accordance with local codes. Connect the white neutral to the service neutral.
The chart below recommended the minimum circuit protection and wire size if the appliance is the only unit on the circuit.
RECOMMENDEDMINIMUM
K.W,RATING CIRCUITPROTECTIONWlRESIZE
ONSER_LPLATE IN_PERS (AWG)
0- | 4.8 | 20 | 12 _'_ |
4.9 - | 6.9 | 30 | 10 |
7.0- 9.9 | 40 | 8 | |
10.0- 11.9 | 50 | 8 | |
60 | 6 | ||
Service
Interruptthe source of electricity to the unitwhen attempting to repair or service the oven. Failure to do this could result
in a dangerous or even fatal shock.
IMPORTANT- SAVE FOR LOCAL ELECTRICALINSPECTOR'SUSE
PartNo,209630A
