Installation of LP Orifice Spuds
_= .°(
L
P""0
// "_ _ _
ART
Figure 6
B. Invert Cap in Appliance Pressure Regulator
(See figures 7 and 8.) With the appliance installed, the regulator is located on the underside of the burner box on the
right hand side at the inlet to the gas manifold. Identify the make of appliance regulator on the unit and follow the
R._ | I | LP |
| RER.ACEPININCAP, . |
CAP | ,_ | FINGERPRESSURE | ||
J | _ | TO_ | PIN | |
CONVERTE |
|
| APPLYSIDEWARD | |
NATjl r |
| _ _ |
| I '± |
Figure 7: Conversionof Maxitrol
Appliance Pressure Regulator
With a quarter, engage slot and rotate cap 1/8 of a tL
counterclockwise. To remove cap, turn cap over and reinst_
00
NaturalSetting | LP Setting |
Figure8: Conversionof
Appliance Pressure Regulator
After conversion, steps A and B have been completed, che¢ the appearance of each burners' flame at the Hi and L
small, review all steps to make sure they were complete
correctly.
settings against figure 9. If the flames appear too large or to
| __ | ||||
,/ |
|
| I_1o |
|
|
,2.., |
|
| I; | - | _ |
5 | 6 | 7 | 8 |
|
|
Figure 9: Flame Appearanceat Hi and Lo
