InstallingCabinetryOverYourJenn.AirGrill
*A = 30" (76.2 ¢m) minimum vertical clearance between cooking surfaceand construction above the appliance.
*B = 13" (33.02 cm) maximum depth of cabinets installed above cooking top.
of local codes, with the latest edition of the National Electrical Code ANSI/NFPA No. 70 USA or currant CSA STANDARD C22.1 Canadian Electrical Code part 1.
IDottedlines indicate
'rangehood
iconstruction
*To eliminate associated potential hazards such as
reaching over open flames, avoid use of cabinets above | Cabinet Bottom |
cooktop for storage space. | Figure 2 |
CabinetsAboveCookingTop
Maximum depth of cabinets installed above cooking top is 13 inches.
CAUTION: SOME CABINETS AND BUILDING MATERIALS ARE NOT DESIGNED TO WITHSTAND THE HEAT PRODUCED BY THE NORMAL SAFE OPERATION OF A LISTED APPLIANCE. DISCOLORATION OR DAMAGE, SUCH AS DELAMINATION, MAY OCCUR.
InstallationOf Appliance
Followaccompanyingducting instructionscarefully.
This appliance is designed to always be vented outdoors. The Countertop Cutout, Cabinet Front Cutout and Duct
Opening shouldbe prepared accordingto the illustrationon pages 1 and 2.
The installationof this appliancemust conform with local codes or, in the absence of local codes, with the latest
editionof the National FuelGas Code, ANSI Z223.1 USA or
The electricalsupplyrequiredis 110/120 Volt,A.C., 15 amp, 60 Hz. This appliance is equipped with a grounded tpe power cord. A grounded outlet must be provided. It is recommended, for convenience, this outlet be located inthe area shown in the shaded illustration (see figure 2).
This appliance, when installed, must be electrically groundedin accordance with local codes or, in the absence
ConnectingApplianceToGasSupply
A TRAINED SERVICEMAN OR GAS APPLIANCE
INSTALLER MUST MAKE THE GAS SUPPLY _ - | ._ | |
CONNECTION. Leak testing of the appliance _1"_ | . | ''_ |
conducted by the installer according to the _
Installa manualshutoffvalve inan accessiblelocationinthe gas lineexternalto this appliancefor the purposeof turning on or shuttingoffgas to the appliance.
Make the gas connection to the inlet to the appliance pressure regulator on this appliance with a 1/2" male p_pe
thread. Use an approved pipe joint compound resistant to
the action of LP gas at pipe connections. Test all joints for gas leaks with a soap and water solution or other accepted
leak detection means. Never test for gas leakswith an opeIT" .. :: flame....
