Jenn-Air JXT8836ADS Controls Filter Change Indicator Carbon Filters, Filter Replace Indicator

CONTROLS & FEATURES 3

CONTROLS: FILTER CHANGE INDICATOR (CARBON FILTERS)

Filter Change Reminder (Carbon, if fitted):

When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of Carbon Filters to purify exhaust and fumes from cooking, then re-circulate the air within the home. These Carbon Filters are required to be replaced after every 120 hours of use. The Filter Change Reminder function in the microprocessor needs to be switched on. The microprocessor in the

controls when set, will elapse and count usage time and indicate by a flashing when carbon filter replacement is needed.

Setting the Filter Change Reminder:

When Off, hold for approx. 5 seconds. The display will change from

(exhaust mode) to , (purifying mode/ carbon filters used) this indicates that the elapse timer function is switched on and Carbon Filters are used.

Filter Replace Indicator:

When the display starts flashing, the Carbon Filters require replacement.

Re-setting Function:

Once filters are replaced, with hood off,

press and hold , the display will appear; hold for approximately 5 seconds until

on display disappears . The Filter Change Reminder is now re-set and a new 120 hours elapse cycle is initiated.

Set Mode

hold 5 secs.

Change Filters

To Reset

hold 5 secs.

display from <--> to <C>

display <C> flashes

display from <C> to < >