Cabinet-front mounting

1

2

3Changing the Decorative Panel

There are three options for changing the decorative panel:

■ Order an acrylic panel

■ Create a custom panel for use with a trim kit

■ Create a custom panel for installation without trim

 

To order an acrylic panel or a trim kit, see the “Assistance or

4

Service” section for information or call the toll-free number on the

cover.

 

1.Mounting clip

2.Cabinet

3.Retaining bracket

4.Mounting screw

7.Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so drawer will go over drawer stops. Close drawer. Check to see if drawer opens freely. If the toe plate rubs against floor, see “Adjusting the Toe Plate” for further instructions.

Adjusting the Toe Plate

If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows:

1.Mark on each side of the toe plate the amount of toe plate that rubs the floor covering.

2.Remove the drawer from the unit. (See Step 3 in the “Unpacking” section.)

3.Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe plate.

4.Use scissors or utility knife to cut toe plate along line.

5.Replace drawer. If toe plate still rubs floor covering, repeat steps 1-4.

Air Freshener

The solid air freshener system is designed to help control odors that might develop in the trash. An air freshener disc can be purchased in department stores (not sold with compactor). Place the disk-shaped solid air freshener into the air freshener compartment. The air freshener should last 4 to 6 weeks. It is used more rapidly when the temperature is high or the air is very dry.

Trim kit panel dimensions

Use these dimension drawings to create a custom panel for use with a trim kit. Then, follow the installation instructions provided with the kit.

Flat panel: A ⁷³² in. (5.6 mm) thick panel is required. This is the same thickness as a standard ¹₄ in. plywood or paneling.

231316 "

(60.5 cm)

145 8 " (37.2 cm)

Raised panel: The outer section of panel must be ⁷³² in. (5.6 mm) thick to fit into trim. Design raised panel sections using dimensions shown above.

 

14

5

8

"

 

1

 

 

7 32"

 

 

 

1

 

 

"

(37.2 cm)

 

4

(5.6 mm)

 

 

 

 

(32 mm)

 

 

 

 

 

 

 

 

1

 

 

 

 

2313 16 "

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

 

(60.5 cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

5 16"

 

(8 mm)

5 16 "

both sides

(8 mm)

1.Raised panel or decorative trim

2.Outer section of panel

7