Jenn-Air W10208727A Install Moisture Barrier on some models, No waste disposer no air gap

Option B, No waste disposer – no air gap

No waste disposer – no air gap

				ScrewLarge-typsilver
				drainclamphose clamp
		Waste tee
				Drain hose
			Drain trap
1	Black end	1. Connect black end of of drain hose to
			waste tee and cut if needed.
			(Do not cut ribbed section.)
2		2. Attach black end of drain hose to waste
			tee with a large silver drain hose clamp
			(provided). Use pliers to squeeze clamp
			open and move into position. If the drain
			hose was cut, use a 1 1/2” to 2” (3.8 to
			5 cm) screw-type clamp (not provided).
Option C, Waste disposer – with air gap
Waste disposer – with air gap
				Air gap
		Screw-type clamps		Large silver drain
	Disposer inlet			hose clampl
				(provided)
				Rubber hose
				connector
				Drain hose
				Drain trap

Option D, No waste disposer – with air gap

No waste disposer – with air gap

Screw-type clamps				Air gap
			Large silver drain
				hose clamp
					(provided)
Waste tee				Rubber hose
					connector
					Drain hose
	Drain	trap
1 Black end	1. Connect black end of drain hose to air
	gap and cut if needed. (Do not cut
	ribbed section.)
	2. Attach drain hose to air gap with large
2	silver drain hose clamp (provided).
	Use pliers to squeeze clamp open and
	move into position. If the drain hose
	was cut, use a 1 1/2” to 2”(3.8 to 5 cm)
	screw-type clamp (not provided).
3	3. Use a rubber hose (not provided) with
	screw-type clamps (not provided) to
	connect from waste tee to air gap.

Install Moisture Barrier (on some models)

Install moisture barrier (on some models)

1

2

3Black end

4

5

1.Using a hammer and screwdriver, knock plug into disposer.

2.Use needle-nose pliers to remove plug.

3.Connect black end of drain hose to air gap and cut if needed. (Do not cut ribbed section.)

4.Attach drain hose to air gap with large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1 1/2” to 2” (3.8 to

5 cm) screw-type clamp (not provided).

5.Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet.

Moisture barrier

1.Make sure the area under the cabinet is clean and dry for installation of the moisture barrier.

2.Remove the backing of the moisture barrier and apply to underside of the countertop along the front edge of the counter.

10