Prepare Custom Wood Door Panels
IMPORTANT: For an armoire installation, before drilling holes along the top edge(s) of the custom door panel(s), you must adjust the placement of the drilling template (provided with the
NOTE: The only offset dimension is the 6⁵⁄₈" (16.8 cm) offset from the top of the door panel.
refrigerator).
NOTES:
■No template adjustment is needed for the bottom edge of the door panel(s).
■No template adjustment is needed for the custom freezer drawer panel.
1.Align the drilling template on the back of the custom door panel so that the top of the template is offset 6⁵⁄₈" (16.8 cm) from the top of the door panel.
35³⁄₄"
(90.8 cm)
A
C
6⁵⁄₈" (16.8 cm)
B
59¹⁄₁₆"
(150 cm)
A. Top of custom door panel
B. Drilling template
C. Bottom of custom door panel
2.Continue to use the template as you normally would along the bottom, handle side of the door panel.
Complete Installation
IMPORTANT: Return to the instructions provided with your refrigerator to complete the installation. See “Prepare Custom Overlay Panels” in the Installation Guide.
9