Jenn-Air W10298937A Installation Requirements, Tools and Parts, Location Requirements

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

■	Tape measure	■	Marker or pencil
■	Flat-blade screwdriver	■	Pliers
■	Phillips head screwdriver	■	¼" drill bit
■	Drill	■	Jigsaw
■	Level	■	Ratchet with ³⁄₈"socket

■6" socket extension

Parts supplied

■Vent grille

■Grease filter

■Grill cartridge

■Grease container(s)

Parts needed

■ A UL listed or CSA approved strain relief for ⁷⁄₈" (2.2 cm)

knockout.

■ A UL listed or CSA approved conduit connector for

¹⁄₂" (1.3 cm) trade-size metal-clad conduit

■ UL listed wire connectors

■ Metal ducting

■ Jenn-Air wall cap

Jenn-Air®6" (15.2 cm) Round Surface Wall Cap Damper

Order Part Number A406

®

■Use the countertop opening dimensions that are given with these Installation Instructions. Given dimensions are minimum clearances and provide 0" (0 cm) clearance.

■Grounded electrical supply is required. See “Electrical Requirements” section.

■If cabinet has drawers, drawers will need to be removed and drawer fronts installed on front of cabinet.

IMPORTANT: An under-counter built-in oven cannot be installed under this product.

Product Dimensions

30" (76.2 cm) Cooktop

BC

A D

E

F

A. Tie down bolt (on each side of cookop)

B. 30" (76.2 cm)

C. 21³⁄₄" (55.3 cm)

D. Grease containers

E. Wiring box cover

F. Blower

Jenn-Air 3¼" x 10" (8.3 x 25.4 cm) Surface Wall Cap Damper

Order Part Number A403

To order, see the “Assistance or Service” section of the Use

and Care Guide.

■ Vent clamps

Check local codes. Check existing electrical supply. See “Electrical Requirements” section.

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

B

A*

C

D**

E

F

G

C H

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. When installing cooktop, use minimum dimensions given.

■To eliminate the risk of burns or fire by reaching over the heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.

A. 6¹⁄₄" (15.9 cm)	E. 13³⁄₄" (34.9 cm)
B. 3¹⁄₂" (8.9 cm)	F. 11¹³⁄₁₆" (30.0 cm)
C. Grease containers	G. 4" (10.2 cm)
D. 2" (5.1 cm)	H. 13¹³⁄₁₆" (35.1 cm)

*A minimum clearance of 6¹⁄₄" (15.9 cm) is recommended for removal of the grease containers. Installed dimension for the grease containers is 5¹⁄₂" (14.0 cm).

**A minimum clearance of 2" (5.1 cm) is recommended between the motor/blower and cabinet for proper cooling.

2