Jensen JCD3010 operation manual Tuner Operation

JCD3010

Display Selector (DISP)

This unit can display either the clock time or radio frequency/CD player functions. Press the DISP button (6) on the control panel or remote control to display the time for approximately 5 seconds. The correct time of day can be set by pressing and holding the DISP button.

Setting the Clock

To set the clock, perform the following steps:

1.Press the DISP button (6) to display the clock.

2.Press and hold the DISP button (6) until the time display flashes.

3.Within 5 seconds, press the TUNE down button (18) to adjust the minutes to the desired setting.

4.Press the TUNE up button (19) to adjust the hour.

5.Press the DISP button again to return to radio frequency or disc play or wait five seconds and normal operation will resume automatically.

Preset Equalizer (PEQ)

The preset equalizer applies preset sound effects to the unit’s audio output signal. To adjust the preset equalizer, press the PEQ button (23) on the remote control. Press repeatedly to choose between the following modes: “FLAT”, “CLASSICS”, “POP M”, “ROCK M” or “DSP OFF”.

TUNER OPERATION

1	12	7	6	5	21	4	19	3	2
									JCD3010
9
17
10
13
11
14	15	22	16		8		18		20

Select a Band

Press the BAND button (21) on the control panel (or BND on the remote control) to change between three FM bands and one AM band. Each band stores up to six preset stations.

Tuning

Auto Seek Tuning

Press the TUNE up (19) or TUNE down button (18) on the control panel (or U and D on the remote control) for less than three seconds to move to the next station automatically.

Manual Tuning

Press the TUNE up (19) or TUNE down button (18) for more than three seconds to enter manual tuning mode. Press the TUNE up or TUNE down button to change the radio frequency number up or down one step.

Scan

Press the SCAN button (22) on the control panel (or SCN on the remote control) to automatically search for stations. Each available station will flash on the display for a few seconds before the next is searched. To select a “flashing” station, press the SCAN button again.

Preset Stations

Six numbered preset buttons store and recall stations for each band.

Store a Station

Select a band (if needed), then select a station. Hold a preset button (9-14) for three seconds. The preset number will appear in the display.

Recall a Station

Select a band (if needed). Press a preset button (9-14) to select the corresponding stored station.

6