the unit for at least 10 minutes. After 10 minutes, reinsert the batteries, plug the unit back in and press the RESET button again.
| SPECIFICATIONS |
Frequency Range: | AM 530 - 1720 kHz |
| FM 87.5 – 108.5 MHz |
AC Power Source: | 120V~ 60Hz 5W |
Backup Battery: | 1 x 3V type CR2032 Lithium battery (included) |
Clock Accuracy: | up to +/- 60 seconds per month |
Temperature Sensor Range: 32 °F to 122 °F (0°C to +50°C)
CARE AND MAINTENANCE
1.Children should be supervised when using this appliance.
2.Never wrap the ac power cord around any animal or person. Special care should be taken with long wire.
3.Clean your unit with a dry cloth. Solvent or detergent should never be used.
4.Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5.Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors.
TROUBLESHOOTING GUIDE
Symptom | Possible Cause | Solution |
|
|
|
The Sensor has been | The unit is too close to a wall or | Relocate the clock radio to keep it |
accidentally triggered | there is a barrier (e.g. shelf) | a minimum 3 – 6 inches from a |
| above or behind that is too close | wall and make sure there is no |
| to the clock radio. | barrier (e.g. shelf) above the |
|
| clock radio less than the minimum |
|
| 9 - 12 inches. |
Noise or distorted | - Station not tuned properly for | - Retune the AM or FM broadcast |
sound on AM or FM | AM or FM. | station. |
broadcast | - FM: FM wire antenna is not | - FM: Fully extend FM wire |
| extended. | antenna. |
| - AM: The unit is not placed in | - AM: Reposition the unit until the |
| best reception point. | best reception is obtained. |
AM or FM no sound | - Unit not in “RADIO” function | - Press On/Off Button until radio is |
| mode. | on. |
| - Volume set at minimum | - Increase Volume. |
| - An external non playing digital | - Unplug the Aux In cord |
| audio player is connected to the |
|
| Aux In jack |
|
Sound appears | - Volume control of this unit is set | - Adjust Volume Control to a lower |
distorted at high | to maximum. | comfortable level. |
volume setting |
|
|
LCD brightness is too | - Display brightness set to dim | - Set display brightness to HIGH. |
dim | mode |
|
