Jensen JCR-300 Setting UP Daily Alarms and Clock, Using Manual Settings, Using Talk ’N SET

TALK ’N SET COMMANDS

COMMAND FUNCTION DESCRIPTION AND FACTORY PRESET PHRASE

Hello Clock Radio Trigger word to activate the voice recognition system.

E-6

WHAT IS TALK’N SET?

Talk ’N Set is an innovative clock operating system using the latest voice recognition technology. It’s the HANDS-FREE way to set your alarm clock. No more fumbling with instructions or pressing multiple buttons to set the time and alarm. Once the system is activated by saying the trigger word “Hello Clock Radio”, you now simply say one of the preset voice commands and follow the voice prompts to set-up the clock using your voice! Setting the Time, Alarm, Sleep Time, Sleep Sound and Alarm Sounds are just a few of the features you can control with voice commands.

As you become more familiar with this technical marvel you will understand that it has been specifically programmed for voice command of multiple functions. Depending on the surrounding ambience (potential noise influence) and how you speak its “language”, there may be instances of misunderstood commands. If this happens, just repeat them after checking the way to say your commands so that Talk ’N Set will obey and also talk to you properly. Finally this product can have all functions operated manually the same as all other clock radios.

SETTING UP DAILY ALARMS AND CLOCK

USING MANUAL SETTINGS

In radio off mode, press SET BUTTON (#5) to enter AL1/AL2/Time setup mode.

1.The HOUR DIGITS and AL1 indicator in the LCD panel will flash.

2.Using the > (UP) (#6) or < (DOWN) (#4) BUTTONS, adjust to the desired hour for AL1.

3.Press SET BUTTON (#5). The MINUTE DIGITS and AL1 indicator in the LCD panel will flash (#25).

4.Using the > (UP) (#6) or < (DOWN) (#4) BUTTONS, adjust to the desired minute for AL1.

5.Press SET BUTTON (#5). The SOUND EFFECT INDICATORS of AL1 will flash (#25).

6.Use the > (UP) (#6) or < (DOWN) (#4) BUTTONS to choose a Wakeup Alarm Sound - Ocean, Rain, Brook, Radio or Beep Alarm.

7.Press SET BUTTON (#5) to proceed to AL2 settings following steps #1 to 6 above. AL2 indicators (#26) will respond to the features chosen.

8.Press SET BUTTON (#5) to proceed to TIME settings following steps #1 to 4 above.

9.Press SET BUTTON (#5) to proceed to Sleep Sound settings.

10.Use the > (UP) (#6) or < (DOWN) (#4) BUTTONS to choose a Sleep Sound - Ocean, Rain, Brook or Radio.

11.Except in alarm, snooze or sleep modes, you may cycle through and review the set alarm time, alarm sound and sleep sound settings by pressing the SET BUTTON (#5) repeatedly.

USING TALK ’N SET

For correct operation of TALK ’N SET, please be sure to operate the unit in the following conditions:

-The ambient condition is fairly quiet.

-The radio or alarm sound is not playing.

-The TRIGGER SWITCH (#3) is set to ON. It will say “On” and the “Voice” indicator (#29) will turn on.

-You are within 6 – 24 inches from the built-in MICROPHONE located on the top of the unit right behind the SET BUTTON (#5). (Remarks: the farther away from the mic, the louder you have to say the voice commands.)

-To turn off the TALK ’N SET function, slide the TRIGGER SWITCH (#3) to OFF. It will say “Off” and the “Voice” indicator (#29) will turn off.

-If the unit is placed in an area where there is continuous talking or ambient noises, like near a TV or radio, you may experience a false trigger (“OK” is heard from the speaker). Although rare, if this happens, you can say “Cancel” to stop the function or tap any of the control buttons on the top cabinet to prevent accidental changes in the time, alarm or other settings.