Jensen JiMS-60 owner manual Clock Settings, Radio Operations, Tips for Best Radio Reception

11. FM ANTENNA

22. SLEEP INDICATOR

CLOCK SETTINGS

When you plug the radio to an AC outlet for the first time the clock display will begin flashing "12:00". The flashing will stop when you set the time.

1.In standby mode, press and hold the TIME SET button and repeatedly press the HOUR button to set the correct Hour.

2.Press and hold the TIME SET button and repeatedly press the MINUTE button to set the correct Minute.

NOTE

There is a PM indicator located in the top left-hand corner of the clock display. Be sure to observe the PM indicator when setting the time to make sure the time is set correctly for AM or PM. If the PM indicator is 'On', the time displayed is "PM". If the PM indicator is 'Off, the time displayed is "AM ".

RADIO OPERATIONS

1.Press the ON/STANDBY button to turn the unit on.

2.Slide the FUNCTION selector to the desired radio band, AM or FM.

3.Select your desired station with the TUNING control.

4.Adjust the VOLUME control to the desired listening level.

5.When you have finished listening, press the ON/STANDBY button to turn the radio off.

TIPS FOR BEST RADIO RECEPTION

AM - The AM antenna is built inside the radio. If AM reception is weak, slightly rotate or change the position of the unit until the internal antenna picks up the strongest signal.

FM - If FM reception is weak, fully extend the wire antenna and vary the position and location of the antenna until you find the strongest signal.

Note: To avoid any interference noise generate from speaker, please do not put any iPod models near the system while listening to AM radio.

7