Jensen MSR2007 operation manual Tuner Operation

MSR2007

TUNER OPERATION

Automatically Store / Preset Scan (AS/PS)

1 13 4 2a 14 20 11 3 Automatically Store

15

17

2b

					Select a band (if needed). Press and hold the AS/PS (15) button for more than three seconds
					to automatically select six strong stations and store them in the current band. The new stations
					replace any stations already stored in that band.
		AUDIO		19
					NOTE: During Auto Store (AS), the tuner will default to “Local” mode while scanning the
					band initially. After scanning the entire band once, the unit will switch to “Distant” mode
				18	for all subsequent Auto Store tuning.
	INFO
			12
					Preset Scan
			16		Select a band (if needed). Press AS/PS (15) to scan stations stored in the current band. The
					unit will pause for ten seconds at each preset station. Press AS/PS again to stop scanning
					when the desired station is reached.
					Local/Distant Reception (LO/DX)
SAT					During radio operation, received signals are usually in stereo mode as indicated by the “ST”
					icon. However, when the signals are weak or intermittent, you can activate the Local (LOC)

mode by pressing the LO/DX button (20). This mode favors access to local stations whose signals are much stronger; thereby improving radio reception. Press the LO/DX button again to terminate Local receive mode.

8 6 5 7 9 10

Select a Band

Press the BAND button (16) to change between three FM bands and two AM (MW) bands.

Manual Tuning

Press the TUNE/TRK >> or << buttons (18, 19) to seek stations up/down step by step.

Auto Seek Tuning

Press and hold the TUNE/TRK >> or << buttons (18, 19) to automatically seek the next or previous strong station.

Preset Stations

Six numbered preset buttons store and recall stations for each band.

Store a Station

Select a band (if needed), then select a station. Press and hold a preset button (5-10) for two seconds. The preset number will appear in the display.

Recall a Station

Select a band (if needed). Press a preset button (5-10) to select the corresponding stored station.