MSR3007
INSTALLATION
Before You Begin
1.Disconnect Battery
Before you begin, always disconnect the battery negative terminal.
2.Remove Transport Screws
Important Notes
•Before final installation, test the wiring connections to make sure the unit is connected properly and the system works.
•Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifications to your vessel.
•Install the unit where it does not interfere with driving and cannot injure passengers if there is a sudden or emergency stop.
•If the installation angle exceeds 30º from horizontal, the unit might not give optimum performance.
•This unit is not waterproof and is intended for interior mounting applications only. Exterior mounting of the unit requires use of an ASA approved marine housing.
•Avoid installing the unit where it will be subject to high temperatures from direct sunlight, hot air, or from a heater, or where it would be subject to excessive dust, dirt or vibration.
DIN Front Mount
1. Slide the mounting sleeve off of the chas- Dashboard sis if it has not already been removed. If it
is locked into position, use the removal
7.Carefully slide the radio into the mounting sleeve making sure it is
8.Attach one end of the
perforated support strap
(supplied) to the screw stud on | Dashboard | |
| ||
the rear of the chassis using | Support Strap | |
the hex nut and spring washer |
| |
provided. Fasten the other end | Plain Washer | |
of the perforated strap to a | Screw (4 x 12mm) | |
secure part of the dashboard | ||
| ||
either above or below the radio | Screw Stud | |
using the screw and plain | Hex Nut (5mm) | |
Spring Washer | ||
washer provided. Bend the | ||
| ||
strap, as necessary, to position |
| |
it. CAUTION: The rear of the |
| |
radio must be supported with |
| |
the strap to prevent damage to |
| |
the dashboard from the weight |
| |
of the radio or improper |
| |
operation due to vibration. |
|
9.Test radio operation by referring to the operating instructions for the unit.
Removing the Unit | Removal Key |
To remove the radio after installation, pull back the rubber covers, insert the removal keys
keys (supplied) to disengage it. The
182
straight back until they click, and then pull the
removal keys are depicted in “Removing
radio out. If removal keys are inserted at an
the Unit” on page 2.
53
angle, they will not lock properly to release the
2.Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Do not force the sleeve into the opening or cause it to bend or bow. Check that there will be sufficient
space behind the dashboard for the radio chassis.
3.Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard.
4.Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve.
5.Follow the wiring diagram carefully and make certain all connections are secure and insulated with crimp connectors or electrical tape to ensure proper operation.
6.After completing the wiring connections, turn the unit on to confirm operation (vessel accessory switch must be on). If the unit does not operate, recheck all wiring until the problem is corrected. Once proper operation is achieved, turn the accessory switch off and proceed with final mounting of the chassis.
unit.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
2
