Connecting 12V DC Power for Lighting, Head Unit

Jensen SL210/212 Slot-Loaded Subs Quick Start Guide

WARNING: The rectangular shape of the

Subwoofer provides increased resistance to tipping. To avoid vehicle damage or personal injury that may occur should the enclosure become

detached, please ensure that the enclosure is securely mounted to a surface with adequate strength and rigidity to support it under stress conditions such as road vibration and sudden stops.

NOTICE: There are no removable or serviceable parts on the speaker. Tampering with the speaker or any of it's components will damage the speaker and void the warranty.

Connecting 12V DC Power for Lighting

The lighting features of all Jensen products require a 12 volt power source to operate. The polarity (+ and -) indicators for each set of inputs also appear on the terminal cup.

Do not connect an amplifier or any audio source to Jensen lighting inputs. Inputs

are designed for a switched 12-Volt DC

power source only. Do not connect your Jensen product directly to your battery, as it will cause your battery to discharge.

Be sure to maintain polarity. and be sure to connect to a constant switched 12 volt source. Connect the switched positive (+) 12 volt wire to the Positive (+) lighting input terminal and connect the negative (- ) lighting input terminal to a good chassis ground or negative (- ) ground

12V DC Input for Jensen Lighting

Head Unit

12 volt switched

+ DC source

+12V

Chassis	-	+
Ground

NOTE: Must use 12 volt switched output ONLY.

CARE AND CLEANING: Fingerprints and smudges can be removed from the acrylic by buffing lightly with a lint-free cloth. Light scratches can be buffed out by using an acrylic/plexi polish or fine rubbing compound; however, avoid getting any compound on the cabinet carpeting. The enclosure is the same material used for premium quality home audio speakers, but covered with carpet instead of veneer. Dirt on the carpet can be cleaned with common carpet cleaners and a brush.

SL212

NOMINAL IMPEDANCE: 4 OHM

Audiovox Electronics Corporation

MADE IN CHINA

Wiring Your Bass Enclosure

Connect the positive (+) wire from amplifier output to the positive terminal (red) on enclosure.

Connect the negative (-) wire from the amplifier output to the negative terminal (black) on enclosure.

Need help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.

Jensen SL212 quick start Connecting 12V DC Power for Lighting, Wiring Your Bass Enclosure

Models: SL212