![](/images/new-backgrounds/1221405/2214053x1.webp)
Optional Equipment
•NAV102: Allows you to access navigation features. All installation and operating instructions are included with the navigation module.
•BTM10: Allows you to connect to a Bluetooth enabled cell phone or other device.
•Rear Camera
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative
NOTE: If the VM9224 is to be installed in a car equipped with an
Replacing the Fuse
When replacing the fuse, use a new 20A replacement fuse. Using a fuse with an improper rating could damage the unit and cause a fire.
ISO-DIN Installation
This unit is designed to fit into a 2.0 DIN dashboard opening, found in many imported cars. The unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount the radio to the dashboard. Please consult with your local car stereo specialty shop for assistance on this type of installation.
1Remove the existing factory radio from the dashboard or
| center console mounting. Save all hardware and brackets |
|
| as they will be used to mount the new radio. |
|
2 | Remove the factory mounting brackets and hardware from |
|
| the existing radio and attach them to the new radio. | EJECT |
| CAUTION: Do not exceed M5 X 6MM screw size. Longer |
|
| screws may damage components inside the chassis. | MUTE |
3 | Place the radio in front of the dashboard opening so the |
|
| wiring can be brought through the mounting sleeve. Fol- |
|
| low the wiring diagram carefully and make certain all con- |
|
| nections are secure and insulated with wire nuts or electri- |
|
| cal tape. After completing the wiring connections, plug the |
|
| ISO connectors into the mating sockets on the rear of the |
|
| chassis. Turn the unit on to confirm operation (vehicle ignition switch must be “on”). If the unit does not | |
| operate, |
|
4 | Mount the new radio assembly to the dashboard or center console using the reverse procedure in step 1. |
CAUTION! Be careful not to damage the car wiring.
NOTE: It is the
CAUTION: Do not block the cooling fan exit. If blocked, the unit may overheat and become damaged.
2