Jensen VM9414 owner manual Optional Equipment, Disconnecting the Battery, Pre-installation

Optional Equipment

•BTM10: Allows you to connect to a Bluetooth enabled cell phone or other device.

•Rear Camera

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in- stallation.

NOTE: If the VM9414 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.

Pre-installation

1Remove the four screws that attach the mounting sleeve to the radio and remove the sleeve.

2Install the mounting sleeve.

a.Install mounting sleeve into the dashboard or optional adapter. Do not force the sleeve into the opening or cause it to bend or bow.

b.Locate the series of bend-tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully insert- ed into the dashboard opening, bend as many of the tabs outward as necessary so that the sleeve is firmly secured to the dashboard.

c.Install support strap to make the unit more stable.

3Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve.

CAUTION! Be careful not to damage the car wiring.

TAB

TAB

DASHBOARD

DASHBOARD

2