Wiring
WARNING! Only connect the unit to a
Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the bat- tery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The VM9414 uses one 15 amp fuse, located in the black filter box
Final Installation
After completing the wiring connections, turn the unit on to confirm operation (ignition switch must be on). If unit does not operate, recheck all wiring until problem is corrected. Once proper operation is achieved, turn off the ignition switch and proceed with final mounting of the chassis.
1Connect wiring adapter to existing wiring harness.
2Connect antenna lead.
3Carefully slide the radio into the mounting sleeve, making sure it is
4Attach one end of the perforated support strap (supplied) to the screw stud, which is screwed into the threaded insert on the back of the unit, using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or below the radio using the screw and hex nut provided. Bend the strap to position it as necessary.
5Replace any items you removed from the dashboard.
ISO-DIN Installation
1Remove mounting sleeve brackets.
2Remove trim ring.
3Mount factory brackets on new radio using existing screws from old radio.
4Slide radio chassis into dash opening and secure.
5
5 | 4 |
| |
1 |
|
| 2 |
VM9414 |
|
VOL |
|
AV IN |
|
SEL |
|
| 3 |
CAUTION! The rear of the radio must be supported with the strap to prevent dam- age to the dashboard from the weight of the radio or improper operation due to vibration.
NOTE: For proper operation of the CD/ DVD player, the chassis must be mounted within 20° of horizontal. Make sure the unit is mounted within this limitation.
AV IN |
|
SEL | Remove Mounting |
| |
| Sleeve Brackets |
| ST |
3
