2.
3.Hold the set screw in position with the hex wrench, and
Install Handwheel
Mount the handwheel to the top of the height adjustment screw (Figure 6). Align one of the set screws with the flat on the height adjustment screw, and tighten both set screws.
Install the knob to the threaded hole in the handwheel, and tighten the hex nut against the handwheel.
Install Conveyor Table
1.Lower the table mounting brackets by rotating the handwheel.
2.Remove conveyor table from packaging, and place it on the mounting brackets of the stand. The gear motor should be on the right, or inboard side of the sander as shown in Figure 7.
3.Secure the conveyor bed with four 3/8”x1” hex head bolts, 3/8” flat washers and 3/8” flanged lock nuts.
4.Plug the motor cord into the control box receptacle (Figure 8).
IMPORTANT: The conveyor belt has been overtightened for shipping purposes. It must be tensioned properly before operating the sander! See page 19.
Infeed and Outfeed Tables (Optional
Accessory)
See Figure 9.
1.Remove the lower hex cap screw (A) and square nut (B) from the rail on the infeed side of the sander.
2.Slide a left hand mounting bracket (C) into the end of the rail.
3.Align holes and
(A)and square nut (B). Install a 3/8”x1” hex head bolt (D), 5/16” flat washer (E) and flanged lock nut (F).
4.Tighten the hex cap screw (A) first to align the bracket, then tighten the flanged hex nut
(F)on the 3/8” screw.
5.Install a right hand mounting bracket (G) in the same manner. NOTE: You will have to open the control box to remove the screw from the rail – remove the front lower screw and base panel (# 16 on page 38) of the control box.
Figure 6
Figure 7
Figure 8
Figure 9
10
