Spark Plug Removal | Jet Tools J100ECA, J150ECA specification

Spark Plug

1.Remove upper shell (see page 10).

2.Remove fan (see page 17).

3.Remove spark plug wire from spark plug.

4.Remove spark plug from burner head using 13/16" open-end wrench.

5.Clean and regap spark plug electrodes as follows:

.055" (1.4 mm) = 100,000 BTU/Hr model

.075" (1.9 mm) = 150,000 BTU/Hr model

6.Install spark plug in burner head.

7.Attach spark plug wire to spark plug.

8.Replace fan (see page 17).

9.Replace fan guard and upper shell.

(100,000 BTU/Hr Model Shown)

Spark Plug

BurnerWire

Head

Spark

Plug

SPARK PLUG REMOVAL 70, 100 &150	PFA/P 031A
Figure 9 - Spark Plug Removal

Bend Here to Adjust Gap

Image 12

Contents

Portable Forced AIR Heaters Contents Safety Information Carbon monoxide poisoning may lead to death Product Identification 100,000 BTU/Hr Model Unpacking Assembly Tools Needed Theory OperationFuels Ventilation Operation To Start HeaterTo Stop Heater To Restart Heater Storage Preventative Maintenance Schedule Observed Fault TROUBLE- Shooting Service Procedures Upper Shell Removal Fuel Filter Fuel Filter Removal, 100,000 BTU/Hr Model Spark Plug Spark Plug Removal Pump Pressure Adjustment Air Output, Air Intake, and Lint Filters Nozzle Removing Burner Head, 100,000 BTU/Hr Model Removing Burner Head, 150,000 BTU/Hr Model Pump Rotor Rotor Location Fan Fan, Motor Shaft, and Setscrew Location Wiring Diagram Accessory Wheels and Handles Parts Breakdown 100,000 BTU/Hr Model Parts List KEY Part Number Description QTY Illustrated 150,000 BTU/Hr Model NPC-4C Warranty and Repair Service