Assembly
Your bench grinder requires only the assembly of the eye shields and tool rests. For your safety, do not plug the grinder into a power source until all adjustments are complete. An adjustable wrench and a Phillips screwdriver are the only tools you will need to make all normal adjustments and wheel changes on this grinder.
Be sure that the bench grinder is unplugged and the power switch is in the OFF position.
Do not plug in the grinder to power until it is inspected for shipping damage, fully assembled, and moved to it1s permanent location! Failure to comply may cause serious injury!
Do not operate this grinder without all guards and shields in place and in working order! Failure to comply may cause serious injury!
Chipped or cracked wheels can break up and cause serious damage to the grinder and/or severe injury to the operator! Regularly inspect wheels for damage!
Assembling the Spark Guard and Eye
Shield Mounting Brackets
Parts needed:
2Brackets (D) (see Note)
2Lock Knobs (A)
2Spark Guards (C) (see Note)
21/4" x 1/2" Screws (F)
21/4" Flat Washers (B)
21/4" Lock Washers (E)
Note: Brackets (D) and spark guards (C) are marked L (G, Fig. 1) for left side assembly and R for right side assembly.
1.Assemble the left spark guard and eye shield mounting bracket using Figure 1 as a guide. Make sure the spark guard and bracket is marked L.
2.Assemble the right assembly in the same manner.
Figure 1
8
