15
Troubles hooting Trouble Probable Cause Remedy
Drill press will not
start.
Drill press unpl ugged from wall, or
motor. Check all plug connections.
Fuse blown, or circuit breaker tripped. Replace fuse, or reset circuit breaker.
Cord damaged. Replace cord.
Starting capacitor bad. Replace starting capacitor.
Drill press does not
come up to speed.
Extension cord too light or too long. Replace with adequate size and
length cord.
Low current. Contact a qualified electrician.
Drill Press vibrat es
excessively.
Stand on uneven surface. Adjust stand so that it rests evenly on
the floor.
Bad belt(s). Replace belts.
Noisy Operation.
Incorrect belt tension. Adjust belt tension. See the
Changing Spindle Speeds section.
Dry spindle. Lubricate spindle. See the
Lubrication section.
Loose spindle pulley. Check tightness of retaining nut on
pulley, and tighten if necessary.
Loose motor pulley. Tighten setscrews in pulleys.
Workpiece Burns.
Incorrect Speed. Change to appropriate speed; see the
Changing Spindle Speeds section.
Chips not clearing from hole or bit. Retract drill b it frequently to remo ve
chips.
Dull drill bit. Reshar pen, or replace d rill bit.
Feeding too slowly. Increase feed rat e.
Drill bit wander s.
Bit sharpened incorrectly. Resharpen bit correct ly.
Bent drill bit. Repla ce drill bit.
Bit, or chuck not installed properly. Reinstall the chuck, or bit properly.
Wood splinters on the
underside. No backing board used. Place a scrap board underneath the
workpiece to prevent splintering.
Drill bit binds in
workpiece.
Workpiece pinching the bit. Support or clamp workpiece.
Excessive feed rate. Decrease feed rate.
Chuck jaws not tight. Tighten chuck jaws.
Improper belt tension. Adjust belt tension. See the Changing
Spindle Speeds section.