Jet Tools JTAS-10, JTAS-12 XACTA Fence

XACTA Fence

Screw the lock lever knob into the threaded handle

on the XACTA Fence II as shown in Figure 14.

The lock lever has three functional positions as

shown in Figure 15:

• The upright position permits mounting and

removal of fence from the saw.

• The unlock position permits easy fence

positioning.

• The lower position locks the fence to the

front rail. The cam handle should be

pushed down firmly against the pin.

1. Place the fence on the table and lock it.

2. View the fence from the left side of the saw

(Figure 16). Look for the space between the

table and the fence bottom to be equal along

the entire length of the fence (A, B, Fig. 16).

If adjustment is necessary:

3. Unlock the fence.

4. Using a 10mm wrench, loosen the lock nut that

secures the foot adjustment (C, Fig. 16)

5. Rotate the foot, retracting it such that it does

not come in contact with the back rail (Fig. 16).

6. Raise or lower two nylon adjustment screws

(D, Fig. 17) the same number of turns until the

space between the bottom of the fence and the

table is the same. Care must be taken to raise

or lower the fence on each side equally or the

fence may not be 90° to the table after the

height adjustment is performed.

When the space at points A and B (Fig. 16) are the

same:

7. Extend the foot (C, Fig. 16) by rotating it until it

just comes in contact with the back rail.

8. Tighten the lock nut to secure the foot,

preventing it from further rotation.

Figure 14

Figure 15

Fence Side Plate

Table Top

Guide Tube

Back Rail Front Rail

Figure 16

Figure 17