12
Adjusting Fence Parallel to the Miter Slot
1. Place the fence next to the outside edge of the
right miter slot and lock it.
2. The fence should be even with the miter slot
from front to back.
3. If the fence is not even along the length of the
miter slot, unlock the fence, remove it and turn
upside down.
4. Adjust one of the two setscrews (A, Fig. 18)
until the fence is even with the miter slot edge
along its entire length when locked.
Note: You may need to re-adjust the clamping
pressure after aligning the fence.
Clamping Pressure
The XACTA Fence II has been adjusted at the
factory to lock securely when the lock handle is
pushed down. If adjustment is needed:
1. Unlock the fence.
2. Remove the fence from the guide rail.
3. Turn the fence over.
4. Adjust each of the two setscrews (A, Fig. 18)
exactly the same number of rotations until the
fence is held securely when the lock handle is
pushed down.
90° to the Table
1. Place the fence on the saw table and lock it.
2. Place a square (A, Fig. 19) on the table next to
the fence. The fence should be 90° to the
table.
3. If adjustment is necessary, unlock the fence,
and turn one of the two nylon adjustment
screws (B, Fig. 19) until the fence is 90° to the
table.
4. Lock the fence and check the adjustment
again.
Cursor Adjustment
1. Disconnect the table saw from the power
source.
2. Raise the saw blade above the tabletop.
3. Unlock the fence and slide it to approximately
four inches from the saw blade.
4. Lock the fence.
5. Measure the distance between the saw blade
and the inside of the fence.
6. Adjust the cursor (C, Fig. 19) to read the
distance just measured and tighten the cursor
assembly to the fence.
7. Take a test cut and confirm the adjustment is
correct.
Figure 18
Figure 19
Note: If the cursor does not have enough travel to
give the correct measurement loosen the guide rail
and adjust as needed. If you still do not get the
correct measurement loosen the front rail and
adjust as needed. If you have to adjust the front rail
you will need to go through the front rail assembly
instructions again.
This adjustment must be checked whenever a
different blade is installed.
After installing the XACTA Fence II press the black
plastic end caps into the openings of the guide rail.
There is also an end cap for the fence, but this
should already be installed.