JL Audio owner manual C2-350x Specifications, Getting Started, Speaker Placement Considerations

C2-350x Specifications:

Woofer: Injection-molded, Mica-filled, Polypropylene Cone, Polyether Foam Surround

0.75in. Voice Coil on Kapton® Former, Symmetrical Roll Spider Ferrite Magnet

Tweeter: 0.75 in. (19 mm) Silk Dome, Ferrofluid Cooling / Damping Neodymium Magnet

Crossover: Natural Roll-Off Low-Pass, 1st Order High-Pass Filter with Electrolytic Capacitor

Continuous Power Handling: 25 Watts

Recommended Amp Power: 10-40 Watts per channel (RMS)

Efficiency: 83.0 dB @ 1W/1m 89.0 dB @ 1W/0.5m

Sensitivity: 86.0 dB @ 2.83V/1m

Nominal Impedance: 4 ohm

Frequency Response: 130 Hz - 22 KHz ± 3 dB

Included Components and Parts:

•Two C2-350x 3.5-inch (90mm) Coaxial loudspeakers

•Four #8 x 1 inch (25mm) sheet metal screws

•Four Mounting Clips

•Two 5.2 mm female crimpable connectors

•Two 2.8 mm female crimpable connectors

GETTING STARTED

•Turn off the audio system. It is also advisable to disconnect the negative (–) terminal of your vehicle’s battery whenever performing installation work.

•Before cutting, drilling or inserting any screw, check clearances on both sides of the planned mounting surface. Also check for any potential obstacles, such as window tracks and motors, wiring harnesses, etc. Check both sides of the

vehicle, many vehicles are not symmetrical!

•Always wear protective eyewear.

SPEAKER PLACEMENT CONSIDERATIONS

In most cases, your speakers will be placed into factory speaker locations. If you have some speaker mounting flexibility, keep the following in mind:

Lower mounting locations, such as the lower front corner of a door or a kick-panel provide the greatest path length distances for the sound emitted by the speakers. For this reason, they are generally more desirable than higher mounting locations. Higher mounting locations will usually result in extreme near-side soundstage bias which compromises the stereo listening experience.

3