S T E P 4
Remove the air duct body panels as indicated by the image at left. (One on each side of the motorcycle). There may be auxiliary lights installed in this panel, unplug them as the panel is removed.
If you are ONLY installing the pods and NOT the full system, but will be installing an amplifier in the front storage compartment, only remove the air duct body panel on the right hand side (where the harness enters the storage compartment (as seen in STEP 5 below), skip to STEP 6.
S T E P 5
Remove the front Air dam.
S T E P 6
The harness for power, ground, remote turn on, signal and speakers will come down the right side of the motorcycle and enter the storage compartment in the upper right rear corner as shown below.
S t e p 7
Looking down from the top front of the storage compartment, notice where the wire loom enters the compartment.
S T E P 8
Looking up from the front right tire, use a
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, tires, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay.
Always wear eye protection when drilling!
S T E P 9
If you are ONLY installing the pods and NOT the full system, skip to STEP 16.
The two templates shown can be found on the last two pages of the install manual, cut them out and position them as shown.
Remove the panel directly above the storage compartment as indicated by the arrow.
S T E P 1 0
Mark the center positions of each template and cut the two holes, the holes should be
USE ALL PRECAUTIONS WHEN CUTTING/DRILLING!
S T E P 1 1
Mount the bevelled hole trims as shown using the 8 supplied
Page 2 • JL Audio, Inc 2009 | Continued on Next Page |
