S T E P 1 0
Set the enclosure in place and secure the Stealthbox® to the previously installed Mount Brackets. Once all hardware is in location and started, go back through all fasteners and tighten.
S T E P 1 1
It will be easier to go under the vehicle to tighten the four bolts that come through the floor. Make sure to install the Fender Washers, Split Lock Washers and, Hex Head Nuts as shown in the DETAIL below.
D E T A I L |
S T E P 1 2
Step back and admire your work, flip the rear seat back down,
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
|
|
|
| ||
I N C L U D E D H A R D W A R E |
|
|
| ||
4) Custom Mount Bracket | 4) | 1/4” Flat Washer | 4) | 1/4” Split Lock Washer | |
4) | 4) | 3/8” Flat Washer | 4) | 3/8” Split Lock Washer | |
4) | 4) | 3/8” x | 4) | ||
4) 3” x 3” Wax Square |
|
|
|
|
|
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 13TW5
Nominal Impedance: 3Ohms
Continuous Power Handling: 600Watts
P o w e r R e c o m m e n d a t i o n
JL Audio recommends high quality amplifiers such as the JL Audio HD750/1, 500/1v2 or G1700. The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the HD750/1. If another amplifier is being used, please reference this illustration and use similar settings on that amplifier.
All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more detailed information about installing and tuning your amplifier.
C o n n e c t i o n s
Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the
M I D / H I G H F r e q u e n c y D r i v e r F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors
Fits JL Audio Models:
Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door
Fits JL Audio Models:
(954) | w w w . j l a u d i o . c o m |
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
Page 2 • JL Audio, Inc 2008
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A