Cont.
From
Previous
Page
➔
STEP 7: Pull up and remove the cup holders.
Using a 7mm socket, remove the pair of bolts that have been exposed.
➔ ➔ ➔
STEP 8: Using a 10mm socket, remove e the bolt | STEP 9: Once the wire harness is unsecured, dis- | STEP 10: Tilt the console up from the rear.This |
that secures the wire harness. Also remove the pair | connect the white plug. | will expose another harness with a white plug., dis- |
of bolts that secure the console to the floor. |
| connect. |
➔ ➔ ➔
STEP 11: As the console is tilted up, there are more wiring harness that are exposed and that need to be disconnected.
This now should allow the center console to be fully removed out of the Expedition.
STEP 12: With the console out of the Expedition, pull down the rear cup holders. Us e a 7mm bolts that have been exposed.
STEP 13: Using a 17mm socket, remove the bolts that secure the outside walls to the inner black con- sole.
STEP 14: With the outside wall removed, lay the console on its side. Using a 7mm socket, unsecured and remove the wiring harness.
Continued on Next Page ➔
w w w . j l a u d i o . c o m | SB - F - EXPDCNSL/10W3v2, JL AUDIO, Inc 2004 | Pag e 2 | Sheet SKU#011106 Revision6/30/2004 |